Tag Archives: Flowering Fields Designer Series Paper

Flowering Fields Z-Fold Tulips Easter Card

Leave a reply
Flowering Fields Z-Fold Tulips Easter Card

As I looked through my package of the Flowering Fields Designer Series Paper looking to see if a certain pattern was in there, I saw this print of tulips and decided I had to make an Easter card with it right away! As I scored the card in half, I decided to make it a Z-fold card and that’s how this Flowering Fields Z-Fold Tulips Easter Card came about! You never know when you start out what you will actually end up with!

This card was so easy really. I often add pieces of designer paper at least on the folded back front portion but this time I just stamped the smallest tulip in the Flowering Tulips Stamp Set. I used the same Pear Pizzazz ink as the Pear Pizzazz cardstock but I stamped off once on scrap paper because I wanted that light, watermark look down that side panel. I didn’t use the second step of stamping another tulip petal on top of the first because not much was going to show anyway and I just wanted that light look. I did stamp a few leaves to fill in some space.

I die cut a scalloped rectangle from the Scalloped Contours dies (retiring soon!) in So Saffron for the background layer to the tulip paper. For the designer paper, I just measured with a ruler inside the scalloped rectangle and cut out that size rectangle of DSP to fit inside the area. Mine was just a “smidge” under 4″ (about a 1/16th inch less) and about 2 5/8″ wide. If you want to tie a ribbon around that piece, do it before you adhere it to the scalloped rectangle of course.

The greeting is stamped on a die-cut piece from the Stitched So Sweetly Dies (also retiring soon!). I just glued it flat on the card as I am likely to mail this card. I couldn’t resist adding two Iridescent Rhinestone Basic Jewels to the sides of the greeting.

For the inside of the card, to add some interest, I adhered “the other side” of one of the designer papers without a particular pattern except for the shading of colors. This particular piece barely makes a difference in the look from the cardstock, but it’s there and makes a prettier finished look I think.

For the inside, I die-cut a Basic White scalloped rectangle, one size smaller than the card front to adhere inside the card on which to stamp another greeting or write a message and sign the card. You could use one the same size as the front but you would have to line it up perfectly so it wouldn’t stick out from underneath the front card design.

Here is another Z-Fold card I made recently for Easter using the Flowering Tulips Stamp Set instead of the designer paper.

I’ve made lots of Z-Fold cards and I always say they are so easy to make (just fold back the card front!) yet they make such a nice presentation! The recipient will think you are so clever and creative to make such a fancy card! The only difficult part is not to put glue all over the back of the front piece, just on the half that will be adhered to that Z-fold.

Be sure to check the Last-Chance Products list in the Stampin’ Up! Online Store to see what will be retired on May 2 and what is still available. Not everything is discounted, but some things are so grab what you “need”!

Reminder Today is the last day to sign up for Paper Pumpkin to get the April “Change Is Beautiful” Kit!

Flowering Fields Fresh Freesia Easter Card

Leave a reply
Flowering Fields Fresh Freesia Easter Card

If you like purple or know someone who does, I think you will love this Flowering Fields Fresh Freesia Easter Card! Of course, the Flowering Fields Designer Series Paper (the tulip paper, I like to call it!) is so pretty to use on cards! I chose this purple-ish floral tulip pattern to use on this card and I like how it turned out!

The card base is Fresh Freesia, one of the coordinating colors with the Flowering Fields Paper and one of the 2021-2023 In Colors. These colors will be sticking around for another year but the 2020-2022 In Colors will be retiring.

A fancier way to do this card front is to cut the designer paper into strips rather than have a solid piece. These pieces are 1 1/2″ x 3 1/2″ and fit perfectly on the Rich Razzleberry layer that is 5″ x 3 3/4″. You can just eyeball the spacing, making sure it is as even as possible. Lay it out before you glue to make sure everything fits properly! I wanted the Fresh Freesia color to show so I made the margin wider than we usually do.

Before adhering the Rich Razzleberry layer with the strips of designer paper, I wrapped around a piece of Fresh Freesia 3/8″ Open Weave Ribbon. I wanted some ribbon on the card but not something that was going to overwhelm the tulips so this ribbon was perfect. It’s there but you can see through it and it adds a little bit to the card design.

For the greeting, I happened to have the die cut already in my package of Rich Razzleberry cardstock so I wondered it that would be good to use. The “Happy Easter” greeting is in the Celebrating You Stamp Set. This is a great stamp set to have with some basic greetings you will be glad that you have! I stamped it in Rich Razzleberry ink on Fresh Freesia cardstock. I thought Basic White might be too stark against the card since it didn’t have any other white on the card.

The die set I used is the Meadows Dies for the little label with the fancy ends. As I said, I already had one cut in my cardstock so I used that for the layer. After stamping the Easter greeting I cut it with the same die. Then I very carefully trimmed off the curvy ends, leaving the stitching. It just barely fits on the Rich Razzleberry layer even though it overlaps the fancy ends a tiny bit. Then I tied a knot on each end with the Fresh Freesia ribbon, which kind of obscures the die cut, but I still like it. The greeting is popped up with Stampin’ Dimensionals®.

Here is my first Easter card of the season, a Z-Fold card, but it uses another paper in the Flowering Fields package with similar tulips as on this card except in orange colors.

Because you don’t have to figure out the measurements for a card like this, just copy mine, this card will be easy for you to make! It really didn’t take much time. Easter is less than a month away now, so make some of those pretty Easter cards to send like this Flowering Fields Fresh Freesia Easter card.

Flowering Fields Z-Fold Easter Card

Leave a reply
Flowering Fields Z-Fold Easter Card

The Flowering Fields Designer Series Paper has so many pretty sheets in it! It’s pretty difficult to choose which one to work with! This day, this page with the yellowish tulips is the one that spoke to me! This is just a simple Flowering Fields Z-Fold Easter Card with the designer paper and a little stamping making a bright card for spring.

The card base is Mango Melody, one of the coordinating colors in the designer paper. To make the Z-Fold, just score the front of the card in half, at 2 1/8″ and fold back on itself. It’s really easy and the recipient will think you made an extra-special card! The tulip designer paper on the front panel is cut at 5 3/8″ x 2″. The opposite side of the tulip paper is the one I adhered inside the card. It is cut at 4 1/8″ x 5 3/8″. You could also use the normal layer sizes of 1/4″ margins instead of 1/8″.

Here is a similar card from a year ago that can give you another idea.

On Basic White cardstock I stamped a couple of tulips with the Flowering Tulips Stamp Set. This was two-step stamping using So Saffron and Mango Melody inks for the flowers and Pear Pizzazz for the stems and leaves. After stamping on the Basic White, it was die cut with one of the Scalloped Contours Dies to make this scalloped rectangle. I situated the die so that the flowers would be down lower on the die cut to leave room for a greeting. I found the “”Happy Easter” greeting in the Celebrating You Stamp Set in the Spring Mini Catalog. It is stamped in Mango Melody ink. This piece was then adhered to the front of the card, right on the fold. Be sure to only put adhesive on half of the piece and the other side shouldn’t have any adhesive on it so it doesn’t stick to the inside of the card.

Flowering Fields Z-Fold Easter Card Inside

For the inside of the card, I die cut another Basic White piece the exact size of the scalloped rectangle on the front of the card. I made sure that it was perfectly placed behind the front piece so that it wouldn’t show underneath from the front. To do this I put adhesive on the back of the scalloped rectangle and then held it perfectly behind and against the front rectangle. Then I folded the back of the card over so that the rectangle would then adhere to the inside of the card. It worked! You’ll understand when you actually do it. Now a message can be stamped on the inside of the card or a note written and it won’t be sticking out from the front of the card!

I always say these Z-Fold cards look like something really special but they are easy to make! No one has to know! I hope you will feel inspired with this Flowering Fields Z-Fold Easter Card and make your own, even with different paper and theme! Try it!

Shop the Stampin’ Up! January-June 2022 Spring Mini Catalog!